In stock

Fleece Performance Cummins Crankshaft Barring Tool Fits all Stock 5.9L and 6.7L Stock Dampers and Fluidamprs (FPE-CCBT)

$71.95

Cummins Crankshaft Barring Tool. Turn over your Cummins with ease with this Cummins Crankshaft Barring Tool. It is much easier to use than the barring tool that interfaces the flywheel housing and starter ring gear.

Remove the 4 bolts holding on the damper, install this tool, reinstall the bolts, and torque to spec. You'll never back a bolt out of the damper when trying to reach TDC and overshoot.

They are especially useful when removing and reinstalling a transmission. No need to use a pry bar on the starter ring gear to rotate the engine to remove and replace converter bolts.

Features:

  • Accepts 1/2 inch drive ratchet
  • Designed to be used with factory crank bolts and roll pins
  • No need to remove after installed
  • Built from 1018 steel
  • Works with Vibratech Fluidampr as well as factory dampers
More Information
Manufacturer's Part Number FPE-CCBT
Manufacturer Fleece
Prop 65 WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Write Your Own Review
You're reviewing:Fleece Performance Cummins Crankshaft Barring Tool Fits all Stock 5.9L and 6.7L Stock Dampers and Fluidamprs (FPE-CCBT)

Disclaimer

Product packaging and material may contain more and/or different information from the website, including the product description, country of origin, and other information. Always read instructions and/or information provided with the product before using the product. For additional information about a product, please contact the manufacturer.

Warranty

If you have a product that needs warranty assistance please contact the manufacturer direct as they handle their own warranties.  All product warranties will be at the discretion of the manufaturerar